Algema BLITZLADER 2, Operating Instructions Manual

Page: 21 / 108

4 Operation and running Eder GmbH
20 / 108 Operating Instructions Algema Blitzlader 2 Air - Edition 04/2021
Lack of personal protective equipment!
Squeezing/crushing of hands, fingers and feet.
° Wear personal protective equipment such as protective gloves
and safety shoes during the entire loading and unloading
process.
4.1.2 Loading and unloading point
•
•
Load and unload away from moving traffic whenever possible.
Secure the loading point against moving traffic with hazard warning lights, activated
rotating beacon* and warning triangle. If necessary, enlist the help of another
person to provide security.
• Wear a high-visibility vest.
• Place the car transporter on as level and firm a surface as possible.
• Secure the car transporter against rolling away with the parking brake and, if
necessary, with wheel chocks.
Eder GmbH 4 Operation and running
Operating Instructions Algema Blitzlader 2 Air - Edition 04/2021 21 / 108
4.1.3 Tilt plateau operation
Tipping up and down as well as extending and retracting the loading ramps is done
electrohydraulically. The electrohydraulics are installed in the right front toolbox under the
platform.
The touch panel for operating the body functions and the additional lighting is installed on
the dashboard in the driver's area. The exact installation situation varies depending on
the base vehicle.
Touch panel in the driver's cab:
1. Main button
2. Control lamp set up functions
3. Hydraulic pump indicator light
4. Button manual control
5. Button radio remote control
Hand control panel outside
left:
6. Cable winch unwind
7. Rope winch roll up
8. Ramps from
9. Ramps on
10. Plateau on
11. Plateau from
•
•
• The parking brake of the car transporter must be applied and the ignition switched on
so that the body functions can be activated. If necessary, additionally secure the car
transporter with wheel chocks.
To avoid discharging the vehicle batteries, it is recommended to leave the vehicle
engine running until the charging or discharging process is completed.
• Make sure that the trailer coupling* at the rear is removed.
• Activate the setup functions by pressing the main key (1) on the touch panel. The
control lamp for the set-up functions (2) must light up.
After activating the setup functions, the manual control is automatically active. The
Manual control button (4) and the buttons (6-11) on the manual control panel light up.
If the radio remote control is to be used, it can be activated by pressing the radio
remote control button (5) or directly by pressing the green Start button on the radio
remote control panel.