Algema BLITZLADER 2, Operating Instructions Manual, Page: 78 / 108

5 Care and maintenance Eder GmbH
78 / 108 Operating Instructions Algema Blitzlader 2 Air - Edition 04/2021
Oil change:
•
•
•
• Change the oil once a year.
•
First unscrew the cap of the filler opening so that there is no underpressure in the oil
tank.
• Place a suitable aid (funnel, trough, drip pan) under the drain plug.
• Carefully open the drain plug and slowly drain the oil. It is normal that a small
amount of hydraulic oil remains in the tank.
The used oil must be collected and disposed of properly.
• Then tighten the drain plug again. It is sufficient if the screw is hand-tightened. The
screw and the immediate vicinity should be cleaned of residues before filling up with
new hydraulic oil, so that possible leaks at the drain plug can be detected immediately.
• Using a suitable funnel, refill hydraulic oil HLP22 according to DIN 51524 until the oil
tank is filled to approx. two centimeters below the lower edge of the filler opening.
The changed oil quantity is approx. three liters.
Then screw the lid back in hand-tight.
Remove any possible contamination and check the tightness of the drain plug again.