Alcorn Mcbride Digital Binloop HD, User Manual

Page: 93 / 137

Alcorn McBride Binloop User’s Manual Page 83
Parallel Control
This connector contains various inputs and outputs that can be used to
control and monitor the Binloop. Pins 7-14 are optically-isolated inputs
designed to trigger on 24V. Pins 20-37 are designed to accept a contact
closure between the specified pin and a GND pin (16, 17, 18, or 19).
Pin Signal
1 SMPTE Running output (Contact 1)
2 SMPTE Running output (Contact 2)
3 Fault output (Contact 1)
4 Fault output (Contact 2)
5 Ready output (Contact 1)
6 Ready output (Contact 2)
7 SMPTE Start input (+)
8 SMPTE Start input (-)
9 SMPTE Pause input (+)
10 SMPTE Pause input (-)
11 SMPTE Stop input (+)
12 SMPTE Stop input (-)
13 Mute input (+)
14 Mute input (-)
15 VCC (+5VDC) supplied by Binloop power supply
16 GND
17 GND
18 GND
19 GND
20 Play and Loop clip 1 of group 1.
21 Play and Loop clip 2 of group 2.
22 Play and Loop clip 3 of group 3.
23 Play and Loop clip 4 of group 4.
24 Play and Loop clip 5 of group 5.
25 Play and Loop clip 6 of group 6
26 Play and Loop clip 7 of group 7.
27 Play and Loop clip 8 of group 8.
28 Reset SMPTE.
29 Idle SMPTE (refresh)
30 Reserved
31 Stop sounds selected by inputs 20-27 (else play).
32 Inhibit the looping of sounds selected by inputs 20-27
33 High = SMPTE Locked, Low = not locked
34 High = Video Sync locked, Low = no sync detected
35-37 (not used)