Alcatel Speed Touch Wireless, User Manual

Page: 274 / 362

17 Maintenance - Lost Speed Touch Wireless
274 / 362
3EC 17766 AAAA TCZZA Ed. 01
17.2.3 SwitchĆtoĆDefaults
At the back of the STWireless there is a a set of DIP switches
labeled "Config".
Via these switches a hardware reset of the
STWireless , the
SwitchĆtoĆDefaults , is possible.
Proceed as follows:
Step Action and Description
1 Make sure your STWireless is turned on.
2 Put DIP switch number 4 in the UP position:
Config Console
You will notice that the PWR/Alarm LED flashes amber.
3 Power cycle the STWireless and wait to allow the POST to end.
The STWireless will come online with manufacturing defaults.
4 Reset the DIP switch in its original position. If not, the 'PWR/Alarm'
LED will flash amber as a warning.
5 After a reset to original defaults a reconfiguration of STWireless 's
IP address might be necessary.
This because the reset to defaults also resets your
STWireless 's IP
address to its default value 10.0.0.138.
DIP Switch Position
Leaving the DIP switch in the UP position, will cause unintended
reset to manufacturing defaults !
CAUTION