Alcatel Speed Touch Wireless, User Manual

Page: 269 / 362


17 Maintenance - Lost Speed Touch Wireless
269 / 362
3EC 17766 AAAA TCZZA Ed. 01
Step Action and Description
4 Add a static entry to the ARP cache, according to following syntax:
arp –s <STWireless IP address> 01–90–D0–80–01–01
or
arp –s <STWireless IP address> 01:90:D0:80:01:01
<STWireless IP address>
is a placeholder for the IP address
to be assigned to the STWireless .
5 Verify if this step was successful. Execute:
arp –a
a second time.
In the entries list, your
arp –s
command entry should be added.
6 Turn on the STWireless and allow the POST to end.
7 Ping the IP address you just entered in the ARP cache within 60
seconds:
ping <STWireless IP address>
8 If successful, the STWireless has configured this IP address and
will reply to the ping.
8 You may clear the entry in the ARP cache by issuing the following
command:
arp –d <STWireless IP address>
Note : Leaving the entry in the ARP cache does not harm the
general operation.
10
Browse to the STWireless web pages, and click to
make the new IP address permanent.
If your PC is equipped with multiple PCĆNICs, or WLAN adapters,
make sure that the procedure is applied to the one which joined
the STWireless . WLAN environment.
In the following syntax,
<Interface IP address>
identifies the
particular PCĆNIC:
arp –<a,s,d> <STWireless IP address> –N <interface IP
address>
IP Addresses and Subnet Masks
Make sure that the intended STWireless IP address and your PC
share the same IP (sub)network.
If not, the ping will be submitted with the MAC address of the
default router instead of the special MAC group address.
CAUTION