Alcatel-Lucent 7710 SR SONET, Configuration Manual

Page: 204 / 496

MDA Commands
Page 178 7710 SR OS Interface Configuration Guide
secondary-override
Syntax secondary-override
Context config>card>mda>ingress>mcast-mgmt
Description
This command enables the context to configure secondary path limit override parameters.
scheduler-policy
Syntax scheduler-policy hsmda-scheduler-policy-name
no scheduler-policy
Context config>card>mda>ingress
Description
This command overrides the default HSMDA scheduling policy on the ingress MDA. The command can
only be executed on an MDA provisioned as a HSMDA. Attempting to provision a scheduler policy on a
non-HSMDA will fail. The defined hsmda-scheduler-policy-name must be an existing HSMDA scheduler
policy. An HSMDA scheduler policy that is currently associated with an HSMDA cannot be removed from
the system.
When the scheduler policy is changed on an ingress HSMDA, the ingress scheduling parameters are
immediately changed to reflect the parameters within the policy.
The scheduler policy defined on the ingress context of an HSMDA cannot be changed when local scheduler
overrides exist. The scheduler overrides must be removed prior to changing the scheduler policy. Once the
scheduler policy is changed, any required overrides may be redefined.
The no form of the command restores default HSMDA scheduler policy control over the ingress scheduler
on the HSMDA. The no scheduler-policy command cannot be executed when scheduler overrides exist on
the ingress HSMDA. The overrides must be removed prior to executing the no scheduler-policy command.
Parameters hsmda-scheduler-policy-name — Specifies an existing policy created in the config>qos>hsmda-scheduler-
policy context. The “default” policy name cannot be specified. Instead, the no scheduler-policy
command should be executed resulting in the default scheduler policy being used by the ingress MDA.
sync-e
Syntax [ no ] sync-e
Context config>card>mda
Description This command enables synchronous Ethernet on the MDA. Then any port on the MDA can be used as a
source port in the sync-if-timing configuration.
The no form of the command disables synchronous Ethernet on the MDA.