5
Suburban DynaLine Owner's Manual 04/2021 Rev.4
SLOPE DOWN TO THE OUTSIDE
1"
4
SURFACE OF FINISHED
FLOOR OR TOP OF CARPET
MIN. (PROJECTION BEYOND EXTERIOR WALL)
1"
4
3 (MIN.)
1"
2
Y"
X"
MOUNTING HOLES AND SCREWS
(BY INSTALLER.)
DO NOT PUT HOLES THROUGH
WALL SLEEVE BOTTOM!
REAR GRILLE
CAULK AROUND WALL SLEEVE
SURFACE OF FINISHED EXTERIOR WALL
Y" = 14
SURFACE OF FINISHED INTERIOR WALL
CABINET FRONT
X" REPRESENTS EITHER THE
DIMENSION REQUIRED TO FLUSH
SLEEVE TO FINISHED TRIM OR
MOLDING, OR THE DISTANCE
SLEEVE PROJECTS INTO ROOM
BEYOND FINISHED INTERIOR
WALL.
NOTE: X" CAN BE 0"
IF SLEEVE IS FLUSH
WITH FINISHED
INTERIOR WALL.
4 - ( X" + )
4
3
1
WALL INSTALLATION
FRONT GAS HOOKUP
WALL INSTALLATION FRONT GAS HOOK-UP
Figure 5
GASKET
NOTCH FOR OPTIONAL
REAR GAS HOOKUP
BE SURE DRAIN
HOLES ARE TO
OUTSIDE
REAR
FRONT
SLEEVE TOP
INSERT SIDES BETWEEN TOP FLANGE
AND RETAINING ANGLE
SLEEVE BOTTOM AND SIDES
Figure 6
BIRD GUARD
SCREW #8 X 1/2
Figure 6A
CAULK (MUST BE WATER TIGHT).
DRAIN TUBE ASSEMBLY INSTALLED
UNDERNEATH WALL SLEEVE
NOTE: FOR THIS TYPE INSTALLATION,
WALL SLEEVE MUST EXTEND BEYOND
WALL A MINIMUM OF 1 1/8".
LOCATE DRAIN IN
BOTTOM OF WALL
SLEEVE. MUST BE
TO THE EXTERIOR
SIDE OF BUILDING.
AT DESIRED LOCATION
MARK AND DRILL ONE
9/16" DIA. HOLE AND
TWO 1/8" DIA. HOLES
AS ILLUSTRATED.
CAULK (MUST BE WATER TIGHT).
PRIMARY DRAIN HOLES FOR
CONDENSATE DRAINAGE TO
BUILDING EXTERIOR WHEN
USING ACCESSORY DRAIN KITS.
NOT
DRAIN TUBE ASSEMBLY INSTALLED
ON REAR FLANGE OF WALL SLEEVE
Figure 7