Airwell PAC BT Series, Installation And Operating Manual

Page: 15 / 112

13
2 - INSTALLATION
D
Condensate discharge connection Ø 13
E
Frost line
F
Layer of gravel or pebbles to help with condensate
drainage
To avoid freezing of the water downstream of the drain lay the
tube below the frost line (
E
).
Position the indoor unit on a flat, level surface.
Install the feet supplied (A)
2.4 -
LEVELLING INDOOR UNIT
Condensate discharge via drainage
Use a spanner (36mm) to adjust the support feet and level the
position of the indoor unit.
When a heat pump is running it produces a considerable
amount of water due to the defrosting cycles of the outdoor
coil.
The condensation must be eliminated in a manner to avoid
wetting pedestrian areas.
With extensive very cold outdoor temperatures, condensation
could freeze outside the unit blocking the flow and causing a
slow build-up of ice; therefore special attention must be paid
to eliminating condensation, raising the unit off the ground and
evaluating whether antifreeze elements should be installed.
Condensate drain
A
Condensate collection basin
B
Unit support
C
Condensate discharge connection
Customer care accessories