ahlmann AS 210, Operating Instructions Manual

Page: 11 / 116

S220/S221/S230/S231/Z200 1-5
Safety Regulations 1
1.5.1.9 Avoid any action which appears to be dangerous!
1.5.1.10 Persons must not be carried in the working
equipment, e.g. in the attachments!
1.5.1.11 The operator may carry out work with the machine
only if no persons are in the danger zone.
The danger zone is the area near the machine where
persons may be injured
- by work-induced movements of the machine,
- by work attachments and devices,
- by loads swinging out,
- by dropping loads,
- by attachments falling from the machine.
1.5.1.12 In case of danger to persons, the operator must
give appropriate warning signs. It may be necessary to
stop work.
1.5.1.13 In case of functional defects, stop the machine
immediately and secure it. Eliminate defects imme-
diately!
1.5.1.14 Check the machine at least once every shift for
external visible damage and defects. Report any defects
(including changes in the operational behaviour) imme-
diately to the person in charge. If necessary, stop the
machine immediately and secure it.
1.5.1.15 The driver may slew the attachments in overhead
driving, operating and working areas only if these areas are
suitably safeguarded by protective roofing. These protec-
tion roofs must offer appropriate safety against loads and
falling goods. If you are in doubt, assume no protection
roofs are present.
1.5.1.16 When driving, the attachment is to be kept as
close to the ground as possible.
1.5.1.17 Please observe the applicable traffic regulations
when driving on public roads, paths or open spaces. The
machine must be brought into road-worthy condition be-
forehand.
1.5.1.18 Make sure to always switch on the lights in the
dark and when visibility is poor.
1.5.1.19 If the lights of the machine are not adequate for
the safe execution of certain work, additional lighting must
be provided on the working site, especially at dumping
points.
1.5.1.20 Should the driver’s sight of his driving and working
area be restricted due to work-induced influences, he must
be given guidance or he must safeguard the working area
by a firm barrier.