ahlmann AS 210, Operating Instructions Manual

Page: 28 / 116

S220/S221/S230/S231/Z200 4-4
4 Description
- Do not switch on the lifting suspension while
the fork-lift or lifting hook attachment is fitted.
- The pipe break protection is disabled when the
lifting suspension is switched on.
4.6 Fan reversal
(option)
The loader is equipped with a fan reversal unit, permitting
the radiator to be cleaned quickly and easily.
Depending on the degree of air pollution in the working
area, the fan reversal unit should be activated regularly in
intervals of 15 minutes (in extreme cases) to daily (in less
serious cases).
To do this, press and hold the fan reversal button (4-12/12).
NOTE
Fan reversal can be activated both when the
loader is at a standstill and when it is moving.
4.7 Wheel change
DANGER
Before changing a wheel on public roads, the
danger area must be properly marked.
(1) Park the loader on a hard surface.
(2) Set the drive switch (4-9/5) to “0”.
(3) Apply the parking brake (4-9/7).
(4) When changing a wheel on the front axle:
- Lift and mechanically prop up the bucket arm [e.g. by
inserting the bucket arm support (option) (1-1/arrows)]
and lower the bucket arm until it rests on the bucket arm
support.
- Block the swivel unit. To do this, remove the blocking
wedge (1-3/arrow) from the holder, insert it into the swivel
block (1-4/arrow) and secure it with the spring locking
lever.
(4) When changing a wheel on the rear axle:
Lower the attachment to the ground.
(5) Turn the ignition key (4-7/5) to the left to position “0”.
(6) Secure the ball hand lever for the working and auxiliary
hydraulics (1-2/arrow).
(7) Ensure that the loader does not roll away by securing
it on one of the wheels of the axis in both driving directions.
The wheel that does not have to be changed is to be
secured.
(8) Loosen the wheel nuts of the wheel to be changed so
that they can be turned manually.
i