ahlmann AS 210, Operating Instructions Manual

Page: 52 / 116

S220/S221/S230/S231/Z200 6-9
Attachments 6
2 3 1
Figure 6-21
Figure 6-22
CAUTION
- When making connections, make sure that
the hydraulic connections are clean and
completely connected and that the colour
codings coincide.
- The grab bucket must be set down with the
grab scoops open. The spacing plate (6-21/1)
welded onto the boom must be inserted
between the two grab scoops.
- The end of the boom and the connected
hydraulic rotary knob rest on the spacing
plate (6-21/2) – which is welded onto the
boom for this purpose – which rests on the
ground.
- The hose guard (6-21/3) may not be used as
a support.
NOTE
Improper connection of the hydraulic hoses may
mean that movements of the grab bucket do not
correspond to the symbols in the sign for the
auxiliary hydraulic system.
DANGER
The grab bucket is mounted and locked correctly
when it is located next to the quick-change device
and the piston rods of the quick-change device
cylinder can be plainly seen (6-22/arrow).
Dismounting
Dismounting is carried out in the same way as for the multi-
purpose bucket (section 6.3.1).
NOTE
The type plate is on the top side of the boom, near
the support.
6.4 Use of additional attachments
DANGER
1. Only those attachments described in these
operating instructions may be used.
2. We emphasise that attachments that are not
supplied by us are also not tested and approved
by us. Use of such products can, under certain
conditions, adversely affect the constructional
qualities of your loader and thus limit the active
and passive driving safety. The manufacturer
cannot be held responsible for damage that
occurs through the use of such products.
i
i