ahlmann AS 210, Operating Instructions Manual

Page: 62 / 116

S220/S221/S230/S231/Z200 8-3
Maintenance 8
8 Maintenance
Figures and descriptions may vary due to modifications in
the construction that become possible and necessary to
improve the loader and to develop it further technically.
These modifications are summarised in section 13.
8.1 Notes regarding maintenance
DANGER
- The engine must be turned off.
- For work to be carried out under the bucket
arm:
- the bucket must be emptied or the
attachment must be relieved,
- the bucket arm must be mechanically
propped up [e.g. by inserting the bucket
arm supports (option) (1-1/arrows)],
- the ball block valve for the working and
auxiliary hydraulics (1-2/arrow) must be
closed,
- the swivel mechanism is to be blocked
(1-4/arrow).
- The loader must be secured against rolling by
applying the parking brake (4-9/7) and by
setting the drive direction switch (4-9/5) to
position „0“. In addition, wheel chocks must
be placed on both sides of one of the two
wheels of the front axle.
CAUTION
- Change the oil when the units are lukewarm.
- Perform maintenance work when the loader
is on level ground and the bucket arm is in its
lowest position.
- Replace damaged filter inserts and gaskets
immediately.
- Clean force-feed lubrication nipples before
lubricating.
NOTE
- For the maintenance work required, refer to
the maintenance plan (page 8-1).
- Damage which is traceable to non-observance
of the maintenance plan is not covered by the
warranty.
- The lubricants listed in the maintenance plan
can be used at ambient temperatures ranging
from -15°C to +40°C .
CAUTION
For ambient temperatures below 15°C, refer to
the description given in section 5.2.2, “Winter
operation”.
i