ahlmann AS 210, Operating Instructions Manual

Page: 65 / 116

S220/S221/S230/S231/Z200 8-6
8 Maintenance
1
2
Figure 8-7
Figure 8-9
Figure 8-8
8.2.5 Oil level check of the hydraulic oil
reservoir
(1) Park the loader in a level position.
(2) Bring the bucket arm to its lowest position and tip the
quick-change device.
(3) Open the engine flap on the right side of the loader.
(4) Check the oil level in the sight glass.
NOTE
The oil level must be visible in the upper quarter
of the sight glass (8-7/arrow). If necessary, fill oil
into the filler neck (8-14/arrow).
8.2.6 Oil change, engine
NOTE
Move the steering wheel of the loader all the way
to the left.
(1) Place a sufficiently large oil drain pan underneath.
(2) Remove the covering plate from the lower part of the
crankcase on the left side of the loader (8-8/arrow).
(3) Unscrew the covering plate of the oil drain plug.
(4) Screw the drainage nozzle with hose from the tool box
(4-1/12) to the oil drain plug.
(5) Remove the cover cap from the hose.
(6) Further procedures are to be found in the Engine
Operating Manual.
8.2.7 Oil change, axles
8.2.7.1 Rear axle
(1) Place a sufficiently large oil drain pan underneath.
(2) Unscrew the plugs from the axle arch (8-9/1 and
8-9/2) and drain the oil.
CAUTION
Waste oil must be disposed of in such a way that
it will not cause pollution!
(3) Screw in the plug (8-9/2) again with a new gasket.
(4) Fill in oil via the plug bore (8-9/1) until the oil level
reaches the opening.
NOTE
- Information about the quantity of oil is given in
the maintenance plan (chapter 8).
- After a few minutes, when the oil level has
lowered, top up the oil until the oil level
reaches the marked level and remains stable.
(5) Screw in the plug (8-9/1) again with a new gasket.
i
i
i