Version October 2014
6
EN
agru SP 63-mobile User’s Manual
2.3
Safety Messages and Information on Remaining Risk
Protect the power supply cord from cutting edges. Have an authorized
service shop replace damaged cables or lines immediately.
The machine has to be operated with a 230 V, 50/60 Hz power supply with
safety fuse or breaker of 16 A maximum. If power is connected through
a power line manifold, the power supply has to feature an earth-leakage
circuit breaker.
The length of the power supply cord must not exceed 10 m (30 feet) from
the circuit breaker.
Caution
Parts Under Power
After opening the machine or removing the cover, parts of it
are accessible that may be under power. The machine may be
opened exclusively by an authorized service shop and only
after it was disconnected from power.
Caution
Pipe Facing Tool
Start the pipe facing tool only when it is in its working position.
When facing pipes, do not wear jewellery; if needed, wear a
hair snood or net. It is forbidden to remove shaving from the
machine while the facing process is running. Make sure nobody
is present in this danger zone.
Caution
Heating Plate and Heating Plate Housing
When working with the machine, be extremely cautious while the
heating plate is operating. Since the plate and its housing guard
present a very high temperature during the welding process, it
must not be operated if unobserved, and sufficient distance to
combustible materials in its surroundings has to be ensured.
Do not touch the heating plate or the plate housing.
The safety
alerts affixed to it have to be complied with strictly.
Caution
Danger of Bruises and Injury
Do not remain in the danger zone while the machine opens or
closes and be sure not to have your hands between the moving
and the fixed parts of the machine.
Caution
Acceptable Work Conditions
The work zone has to be clean and has to have proper lighting.
It is dangerous to operate in a humid environment or close to
flammable liquids. In regard of this, acceptable work condi-
tions have to be ensured (e.g., sufficient distance between the
machine and other functional areas of the workshop).
Overhead work is prohibited, unless:-
• the machine is safely and securely fastened and positioned;
• access to a large area around the worksite is controlled/limited
•
(risk of falling objects); see also Sect. 2.5;
• a hardhat and safety goggles are worn (risk of falling objects and
•
small blades of shaving during component facing)
Important
Power Supply Only through Line with Protective Grounding
Conductor
The machine has to be operated exclusively with a power supply
line equipped with a protective grounding conductor, as a power
supply without this safety element may cause severe machine
damage.
If the machine is operated through a power supply
without a grounding conductor, this will void any and all
warranty under which the product may be.