Version October 2014
EN
15
agru SP 63-mobile User’s Manual
Temperature Unit
(°C / °F)
Menu
In a sub-menu, the temperature unit used for displaying and saving
welding data can be selected.
Buzzer
ON / OFF
if ON: The audible signal that validates certain steps in the process
is turned on;
if OFF: At the end of the respective steps no signal can be heard.
Buzzer Volume
Menu
In a sub-menu, the volume of the audible signal that the machine
emits to validate the execution of a given step in the process can be
set.
Language
Menu
In a sub-menu, the display language of the machine can be selected.
Info
Menu
In a sub-menu, information on the machine and the installed control
software version is displayed.
Contact
Menu
In a sub-menu, information on contact details for sales,
maintenance, and service is displayed.
—— “Advanced Settings” submenu ————————
Memory Control
ON / OFF
if ON: Machine refuses further welding operations when the memory
is full;
if OFF: Machine overwrites the oldest report when the memory is
full.
Date/Time
Menu
In a sub-menu, date and time can be set.
Delete Reports
Menu
In a sub-menu, it is possible to delete
all
welding reports currently in
memory.
To access this sub-menu, the so-called selection code is required;
the reports will be deleted only after another safety warning was
confirmed.
Set Additional
Materials
Menu
Through a sub-menu, the key parameters for welding can be defined
for additional pipe materials that are not installed ex works (see
Sect. 4.5).
4.3
Changing Key Parameters of the Welding
In the default screen (see Display 3), it is possible to change the weld-
specific parameters for the joint to be welded. To do so, press the STOP/
RESET key. The screen that allows selecting the material of the compo-
nents that are going to be welded, is then displayed on the screen (see
Display 6). A selection can be made of default, or standard, (preinstalled)
or extra (user-defined) parameters or materials, using the
,
cursor
keys, and entering additional and traceability data for the welded joint
can also be selected. The selection has then to be confirmed by press-
ing the MENU key.
Additional (extra) parameters may be defined (see section 4.5) for a
maximum of four materials.
No matter whether default/standard or extra parameters were selected,
after pressing the MENU key, first the
,
cursor keys are used to select
the material of the components to be welded, the selection is confirmed
by pressing START/SET, and then, in the next screen, the component
diameter is selected in the same manner.
When you select an additional material, this has to be confirmed by en-
tering the access code for the configuration menu (see sub-section 4.2).
Default materials can be welded without entering this code.
Important
The machine must never be used to weld pipe materials, diam-
eters, and thicknesses other than those available in the welding
parameter screens. The manufacturer is in no circumstances
liable for damage or consequential damage that occurs as a
result of deviations from these pipe data or of modifications or
attempted modifications to the control software. Furthermore,
this will cancel any claims to warranty expressed for the ma-
Display 6
>Sel. Std. Para. -M-
Sel. Extra Para.-M-
Enter Welder -M-
Enter Comm. No. -M-