Agilent Technologies ESA Series, Manual

Page: 88 / 194

88 Chapter 1
Instrument Messages
Instrument Messages
Ins
tr
u
me
nt Messa
g
e
s
12309
No entries in frequency list
A measurement was attempted with List frequency mode or a SCPI query
of the frequency list table was made and the frequency list table is empty.
12310
No entries in ENR table
A measurement was attempted or a SCPI query of an ENR table was made
and there were no entries in the relevant ENR table (Common, Meas or
Cal).
12311
No entries in Limit Line table
An attempt is made to either display or test against a limit line table
which has no entries.
12312
RF re-range required: Meas Restarted.
During a continuous measurement, a change of RF front-end attenuation
was required. To do this the measurement needs to be restarted.
12313
IF over range req. RF re-range: Meas Restarted.
During a continuous measurement, an IF section over range condition
occurred, requiring a change of RF front-end attenuation. To do this, the
measurement needs to be restarted.
12314
No entries in loss table
A measurement is attempted or a SCPI query of a before or after loss table
is made and there are no entries in the relevant loss table
12316
T hot must be greater than T cold
A spot T hot has been specified which is not greater than T cold.
12603
Illegal MSDOS name given
An invalid filename has been specified. Use filenames with a maximum of
8 characters (letters and digits only) and use a 3 character extension. Note
that lowercase and uppercase are perceived as the same.
12604
File already exists
Attempt to store a file that already exists. Delete or rename the old file
and try again
12605
Media is protected
A store was attempted to a write-protected device.
12606
Media is not writable
A store was attempted to a read-only device.
12612
File does not exist
The file you were trying to recall could not be found.