78
Agilent E8462A Relay Multiplexer Command Reference
DISPlay
The
DISPlay
subsystem monitors the channel state of a selected module (or card) in
a switchbox. The DISPlay command subsystem only operates with a RS-232
terminal connected to the Agilent E1405/1406 command module’s RS-232 port.
These commands control the display on the terminal, and would in most cases be
typed directly from the terminal keyboard. It is possible however, to send these
commands over the GPIB interface, and control the terminal’s display. In this case,
care must be taken that the instrument receiving the DISPlay command is the same
one that is currently selected on the terminal; otherwise, the GPIB command will
have no visible affect.
Subsystem Syntax
DISPlay
:MONitor
:CARD <
card_number
> | AUTO
:CARD?
:STATe <
mode
>
:STATe?
DISPlay:MONitor:CARD
DISPlay:MONitor:CARD <card_number> | AUTO
selects the module in a
switchbox to be monitored. NOTE: You must use DISP:MON:STAT ON to
actually display the monitored module state to the RS-232 terminal.
Parameters
Comments
•
Selecting a Specific Module to be Monitored:
Send the card number in a
switchbox with the DISPlay:MONitor:CARD command.
•
Selecting the Present Module to be Monitored:
Use the
DISPlay:MONitor:CARD AUTO command to select the last module
addressed by a switching command ([ROUTe:]CLOSe, for example).
•
*RST Conditions:
DISPlay:MONitor:CARD AUTO
Example
Select Module #2 in a Switchbox for Monitoring
DISP:MON:CARD 2
Select module #2 in a switchbox
DISPlay:MONitor:CARD?
DISPlay:MONitor:CARD?
queries the setting of the DISPlay:MONitor:CARD
command and returns the module in a switchbox to be monitored.
Name
Type
Range of Values
Default value
<
card_number
>
numeric
1 - 99
AUTO
Summary of Contents for E8462A
