Configuring the Agilent E8462A Multiplexer
19
A single-conductor with contact (a crimp-and-insert contact is crimped onto
one end, the other end is not terminated) is available as Agilent P/N
8150-5207.
Front Panel
Connector Pin-Out
Figure 1-6 shows the Multiplexer's front panel and the connector pin-out.
Note
The Agilent E8462A is not supplied with terminal connectors, field wiring
contacts or terminal cards. However, terminal cards can be ordered as an
option.
In Figure 1-6, columns C1 and C2 contain the terminals for the 16-line
multiplexer bus (Ter0 to Ter15) as well as terminals for T_ACCESS* and
T_ERROR*. Ter0 to Ter15 refer to Terminal 0 through Terminal 15.
T_ACCESS* and T_ERROR* are two signals to drive LEDs on the Option
012 Terminal Card. “NC” refers to “Not Connected” and “CGND” refers to
“Chassis Ground”.
Figure 1-5. Connector Block and Single-Conductor Wire with Contact (not provided).
Length: 2 meters
Wire Gauge: 24 AWG
Insulation Rating: 105 C maximum
Voltage: 250 V maximum
Summary of Contents for E8462A
