Agilent Technologies AuroraPresto, User Manual

Page: 62 / 266

Aurora Presto
—User Guide
3-14 481801
Thresholds
(G.SHDSL
only)
This option is only available if you have a G.SHDSL
interface card fitted and you have selected
GL STU R
or
G STU C
in the
Type
option.Use to set up the SNR
(Signal-to-Noise Ratio). Use to set up the low
Signal-to-Noise Ratio threshold. If the Signal-to-Noise
Ratio falls below the level set then a DSL Trace Alarm
will be activated.
Setting up the Trace Route Options
Your
Aurora Presto
may not have the Trace Route
option.
For details contact your Agilent Technologies
representative.
-1-
From the
Select Test Mode
screen press F4
Setup
to display the
Main Setup
screen.
-2-
Select
Trace Route
.
-3-
Press ENTER .
The
Trace Route Setup
screen is displayed.
Src
This displays the Default Gateway
from the WAN setup. You can
accept this or enter the Source IP
address.
Dst
Use this to enter the Destination IP
address.
Msk
This displays the Mask IP Address
the WAN setup. You can accept this
or enter the Mask IP address.
481801-7.book Page 14 Thursday, May 23, 2002 10:46 AM