Agilent Technologies AuroraPresto, User Manual

Page: 104 / 266

Aurora Presto
—User Guide
4-4 481801
Caution: TDR/DMM Tests
When performing Capacitance and Load Coil tests make
sure that voltage is NOT present on the line, if a voltage is
present on the line you may damage
Aurora Presto
.
The Current test is intended for low DC current
measurement only. It is protected by a 400mA fuse.
The TDR/DMM module has protection devices fitted at
manufacture that cannot be reset by the user. If the
protection devices are activated
Aurora Presto
must be
returned to Agilent Technologies for repair.
•
Setting up DMM Tests
—The DMM test is a physical
layer test. See Setting up DMM Tests on page 4-22 .
•
Setting up TDR Tests
— See Setting Up the TDR Tester
on page 4-26 .
•
Setting up DSL Tests
— See Setting up DSL Layer
Tests on page 4-33 .
•
Setting up Ping Tests
—See Setting up the IP Ping Test
on page 4-86 .
•
Setting up ATM BERT Tests
—See Setting up an ATM
BERT on page 4-59 .
•
Setting up F5 OAM PING Tests
—See Setting up the
OAM Ping Test on page 4-68 .
Setting up DSL Test Profiles
Auto Test Mode has 3 DSL Test Profiles. You can assign
Hot Key profiles to each DSL Test Profile.
See Setting up
Aurora Presto
Using Hot Keys on page 3-2 for
information on setting up the Hot Key profiles.
-1-
From the
Select Test Mode
screen, choose
Auto Tests
and press ENTER to display the
Select Tests
screen.
481801-7.book Page 4 Thursday, May 23, 2002 10:46 AM