Agilent Technologies AuroraPresto, User Manual

Page: 238 / 266

Aurora Presto
—User Guide
A2-6 481801
Signal lost
The signal from the far end ATU was lost.
OPEN failed
TO
An attempt to open a connection with a far end ATU
failed due to a timeout.
Note
This occurs if no peer ATU is found (for example, the
line never entered the Training Modem state).
OPEN failed
An attempt to open a connection with a far end ATU
failed during training.
OPEN
rejected
A request to open a line was rejected.
Note
This is typically caused by an invalid set of
configuration parameters being entered.
G.SHDSL Trace Message Definitions
DSL ↓
The G.SHDSL line is idle and/or waiting to retrain.
Seeking Aurora Presto
is seeking a peer STU.
Training Aurora Presto
has detected a peer STU and is training.
DataMode Aurora Presto
has made a connection to a peer STU.
Vendor Codes
The following table list the Vendor Names for the
Vendor Codes printed in Session printouts.
The vendor codes are specified in ANSI T1.413
specification in Annex D.
Vendor Codes
0000 not allocated
0001 not allocated
0002 Westell, Inc.
481801-7.book Page 6 Thursday, May 23, 2002 10:46 AM