Agilent Technologies AuroraPresto, User Manual

Page: 237 / 266

ADSL Status Messages & Vendor Codes
Issue 7 - 05/02 A2-5
Training
Modem
Aurora Presto
has detected a peer ATU and is training.
Connect
Opened
Aurora Presto
has successfully trained and opened a
connection to the peer ATU (for example, Showtime).
Trying G.LITE
Aurora Presto
, configured as an ATU-C in AUTO
mode, has detected a G.LITE device (for example,
failed to open in full rate mode due to a parameter
mismatch) and will reattempt the open in G.LITE
mode.
Note
This is how the Alcatel firmware implements
multimode opens. A transition through IDLE (with a
corresponding trace message) is followed after a
timeout of approximately 5 seconds by an Open
AUTO G.LITE.
ATU Mode
ANSI
After successfully training the device on the far end
was determined to be operating in (ANSI T1.413)
mode.
ATU Mode
G.DMT
After successfully training the device on the far end
was determined to be operating in G.DMT ITU
(G.992.1) mode.
ATU Mode
G.LITE
After successfully training the device on the far end
was determined to be operating in G.LITE ITU
(G.992.2) mode.
ATU Mode
Unknown
After successfully training, the mode the device on the
far end was operating in could not be determined.
Note
This message is included for completeness and will
only occur if the device on the far-end does not
properly identify itself as one of the above types.
Close REQ
A request to close an active connection.
Connect
Closed
A connection was successfully closed.
481801-7.book Page 5 Thursday, May 23, 2002 10:46 AM