Agilent Technologies 1260 Infinity G1315C, User Manual

Page: 266 / 314

266 Agilent 1260 Infinity DAD and MWD User Manual
13
LAN Configuration
Initialization mode selection
Bootp & Store
When Bootp & Store is selected, the parameters obtained from a Bootp Server
become the active parameters immediately. In addition, they are stored to the
non-volatile memory of the module. Thus, after a power cycle they are still
available. This enables a kind of bootp once configuration of the module.
Example: The user may not want to have a
Bootp
Server be active in his
network all the time. But on the other side, he may not have any other
configuration method than
Bootp
. In this case he starts the
Bootp
Server
temporarily, powers on the module using the initialization mode
Bootp & Store
,
waits for the
Bootp
cycle to be completed, closes the
Bootp
Server and powers
off the module. Then he selects the initialization mode Using Stored and
powers on the module again. From now on, he is able to establish the TCP/IP
connection to the module with the parameters obtained in that single
Bootp
cycle.
Figure 88 Bootp & Store (Principle)
5$0
%RRWS
6HUYHU
$FWLYH
3DUDPHWHU
1RQ9RODWLOH
6WRUHG
3DUDPHWHU
N O T E
Use the initialization mode Bootp & Store carefully, because writing to the non-volatile
memory takes time. Therefore, when the module shall obtain its parameters from a Bootp
Server every time it is powered on, the recommended initialization mode is Bootp !