Stay ahead. With Agfa Global Services.
:Anapurna M
4F
- Operator Manual
Maintenance - Test Menu
7
C. MAINTENANCE.
1. Test Menu.
Before you can access the different settings, make sure that the printer is offline. If not, press
the ‘ESC’ button to swith the :Anapurna M4F offline. The test button on the control panel (con
-
trol panel n° 9) gives you access to 4 different test features:
F1 :
PRIME
F2 :
PRIME2
F4 :
BELT TEST
F5 :
DIR TEST
1.1
Prime (F1).
Make sure that a left margin (p.2) is set before you do a prime test. If you press the F1
function key, you will print the following testchart:
For every color a patch will be printed which contains 12 different blocks. Every block
shows you a certain quality and resolution setting or a certain nozzles that are being
fired.
1.2
Prime2 (F2).
Make sure that a left margin (p.2) is set before you do a prime test. The prime2 test
looks like follows:
Two blocks are printed per color. The first block is a solid block showing you the physi
-
cal resolution that is printed in one pass (60 x 60 dpi). The second block is built up
out of lines of 360 dpi, so all the nozzles are firing at the same time with a certain
interval.
1.3
Belt test (F4).
The belt test will allow you to check the positioning of the belt by letting it turn con-
tinuously. Pressing F1 will start the conveyor belt motor, F2 will stop the movement
of the belt. Don’t let the belt test run for more than minutes to eliminate the risk of
size test chart: 65 x 6 cm
size test chart: x 8 cm
