:Anapurna M
4F
- Operator Manual
Stay ahead. With Agfa Global Services.
4
Operations - Changing the parameters
Lower the registration bar by turning the ‘media
set’ button.
Position the left guide on the registration bar us-
ing the scale on the inside of the registration bar.
Before you put your rigid on the vacuum table,
make sure that the shuttle is on the right side
(home position) of the printer.
Position your media against the registration bar
and side guide and turn on the vacuum.
Raise the registration bar by switching the ‘media set’
button back.
Follow the head gap procedure (p.24) to make sure that
the shuttle is set on the correct height.
Check the left margin and n-point paramaters (p.2,) so
that the :Anapurna will start printing on the right spot.
Push the online button and the printer is ready to print.
b. Roll media.
(roll to rol sytem is optional)
If you work with roll media, you can use the auto feed system of the :Anapurna M4F.
It contains two tension bars, a front and rear roll bar and a media roll bar.
The tension bars prevent distortion and waves on the media by applying a constant
tension. The rear roll bar will unwind the media and is steered by a motor which get
impulses from the signal sensors. The front roll bar can be steered in two direction.
It will rewind your printed media, holding a constant tension to reduce distortion.
Make sure that you always insert the tension roll bars in a correct way. The ball
bearing must be placed inside the guide. When you position the bars, make sure
that the both sides are positioned as high as possible into the left and right unit.
Gently lower both sides so that the bars stay completely horizontal for the best
use.
