- 70 -
EZDigPro
User & Calibration Manual
[usage]
Laser Function
LASER REFERENCE
How to work in combination with a rotating laser:
1) Using the laser with reference zero (a benchmark is available on the job site).
Put the bucket on your reference point and press
It's possible to set a manual depth offset at any time, before or after pressing , in case
the physical reference point does not have the same target depth as what you have to dig (eg:
the point is higher).
Take the laser beam
Zero depth will be again at the ref.0 height (plus / minus the manual depth offset set).
After this first initial laser referencing, you should move through the laser beam every time after
you’ve moved the machine prior to start digging to grade.
2) Using the laser plane as an absolute reference (setting the laser beam elevation from
ref.0 keeping the laser button pressed before the first laser catch).
Press & hold to set the distance from the laser beam to the target digging depth.
A dedicated page will appear.
Take the laser beam.
Zero depth will be below the laser beam at the set distance.
In this way to set a manual depth offset is NOT possible and NOT considered if previously set!
The only way to change the reference zero (digging target) on-the-fly while you are working with
the laser is by changing the laser elevation (center line).
You can now move the excavator; take the laser beam again with
before continuing to
dig.
LASER HEIGHT:
0.000
Confirm