- 40 -
EZDigPro
User & Calibration Manual
A summary of the calculated lengths and offsets is shown.
Note: You should check the lengths automatically calculated by measuring the distance between the center of the
pivot points.
It’s also possible to manually adjust the lengths if the element values are already known (written in the machine
documentation).
Note: At this point, the new calculated calibration is not in use and not permanently stored.
The following screen will ask for a confirmation to overwrite the previous calibration.
YES will overwrite the previous calibration and permanently store it.
NO will discard all calculated values.
[automatic calibration]
Booms/Bucket
Calc. Offset:
Boom 1 0.00
Boom 2 0.00
Boom 3 0.00
Bucket 0.00
Calc. Offset:
Boom 1 0.00
Boom 2 0.00
Boom 3 0.00
Bucket 0.00
Calc. Lengths:
Boom 1 0
Boom 2 0
Boom 3 0
Bucket 0
Calc. Lengths:
Boom 1 0
Boom 2 0
Boom 3 0
Bucket 0
SaveCalibration?
Yes
No
SaveCalibration?
Yes
No
Calibration
Done!
Calibration
Done!
The system will be used in combination with a laser transmitter ?
• YES: proceed to laser receiver calibration
next page
• NO: calibration completed! Proceed to Usage section.
Page 60
