- 67 -
EZDigPro
User & Calibration Manual
Press and release to enter the slope setting mode. The correspondent value will flash.
To set the slope, use these buttons:
Press or to set the desired value.
Press to invert the sign (positive / negative).
Press to fast zero the value.
Press to confirm the value and end the setting mode.
The shown slope is now the value used to calculate the depth related to the slope set and the reach position.
Note: The direction of the slope is indicated by the slope icon, based on the assumption that the control box is mounted
on the right-hand side of the driver in the cab.
As shown in the above figure:
Positive Slope: higher in front (e1.00%)
Negative Slope: lower in front (example -1.00%)
-
[usage]
Slope Setting
SLOPE
%
%
NEGATIVE SLOPE (-X.XX %)
LOWER IN FRONT
Left side view
Enter
