32
22. Thread a 4-40 ball link half way onto the
threaded coupler.
23. Repeat above steps for the other side rudder ca-
ble.
24. Attach the ball links to the aft rudder servo arm
using the supplied brass spacers, 4-40 bolts, flat
washers and locknuts.
25. Tape the rudder balance tab to the top leading
edge of the vertical fin in the neutral position as
shown. This ensures the rudder is straight when
the cables are attached.
26. Plug the rudder servo Y harness into the rudder
channel of the receiver and power up. Turn on
transmitter to center rudder servos.
