20
6. Secure the servo connectors with safety wire,
string, tape, or other method. Ensure the con-
nectors will not come apart from vibration or
light tension. Secure excess wire from Y har-
ness and extensions inside the stab root rib using
tape or Velcro as desired.
7. Gather the elevator control linkage parts as
shown below. There are (2) pushrods, (4) 4-40
ball link assemblies, (2) flat washers
(not pic-
tured)
(2) brass spacers, (2) left and (2) right
side control horns, and (12) wood screws per
stab and elevator.
Note:
There is also a
Carbon
tube for reinforcing
the pushrod (
not pictured
). This will be
installed during a later step.
8. Assemble two pushrod and control horn assem-
blies as shown. The ball link goes between the
left and right sides of the control horn sides and
is secured with a nylon lock nut.
5. Plug the elevator servo leads into the female
ends of the 11” Y harness as shown.
