19
2. Assemble the pushrod and control horn assem-
bly as shown. The ball link goes between the
left and right sides of the control horn sides and
is secured with a nylon lock nut. Start with the
center hole in the control horn. The ball link
may be moved up or down for more or less con-
trol throw. Brass spacer goes between servo arm
and ball link
3. Correct installation of ball link to servo arm
shown below.
Note:
Flat washer will prevent ball link from
coming loose from brass ball.
4. Place the control horns over the predrilled
mounting holes.
5. Use a drop of thick CA glue on each screw to
prevent screws from loosening due to vibration
as shown.
Pushrods have both left and right hand threads.
This allows for easier fine adjustments during final
setup. Be sure to thread ball link correctly onto
pushrod. Ball links are self taping and can be used
on either ends of the pushrod. Once ball link has
been threaded only rethread it onto the same direc-
tion threads.
