27
5. Mix epoxy in mixing cup and use a tapered stick
to apply the epoxy inside the pre-drilled holes in
the leading edge of the rudder. Apply epoxy to
trailing edge of each hinge.
6. Carefully slide the rudder onto each hinge and
against the trailing edge of the fin. Wipe away
excess epoxy with alcohol wetted wipes.
7. Ensure there is no gap between fin and rudder.
Allow epoxy to fully cure. Check you have full
rudder deflection before epoxy fully cures.
Rudder Horn, Pull-Pull Cable and
Servo Installation
1. Gather the rudder control linkage parts shown
below.
◊
2 - Rudder cables
◊
4 - Ball link assemblies
◊
2 - Flat washers
◊
4 - Lock nuts
◊
2 - Brass Spacers
◊
4 - Threaded couplers with lock nut
◊
4 - Brass swaging tubes
◊
2 - Left side control horns
◊
2 - Right side control horns
◊
12 - Wood screws
