Aerotech Soloist CP 10, Hardware Manual

Page: 58 / 112

58 Chapter 2 www.aerotech.com
2.3.6. Brake Output (J103)
The Brake Output pins provide a direct connection to either the solid state relay on the Soloist CP or the
mechanical relay on the optional -IO board. The brake output pins in J103 permit the brake to be wired with
other signals in the feedback cable. The brake is configured for automatic or manual control using controller
parameters (refer to the Soloist Help file for more information).
Use either the solid state relay on the Soloist CP or the mechanical relay on the -IO board when connecting a
power supply to the brake outputs on J103. Do not use both relays at the same time.
Refer to Section 2.6. for more information on using the brake output with the solid-state relay.
Refer to Section 3.5. for more information on using the brake output with the mechanical relay.
Table 2-23: Brake Output Pins on the Motor Feedback Connector (J103)
Pin# Description In/Out/Bi
13 Brake Output - Output
25 Brake Output
Soloist CP Installation and Configuration