Aerotech Soloist CP 10, Hardware Manual

Page: 27 / 112

Installation and Configuration Soloist CP
2.1.2. Motor Supply Connections (TB102)
N O T E : This product requires two power supply connections. The Motor Supply and Control Supply
must both be connected for proper operation.
Motor power is applied to the Soloist CP Motor Supply connector (refer to Figure 2-2 for locations).
Refer to local electrical safety requirements to correctly size external system wires and match wires to
fuses or circuit breakers.
The AC1 input is internally fused (5A CP10, 10A CP20/30). External fuses or a circuit breaker (15 A
maximum, time delay type) are required for the AC1 and AC2 inputs. The AC2 input can be connected
directly to Neutral without a fuse for single phase power systems.
W A R N I N G : Do not operate the Soloist CP without the safety ground connection in place.
W A R N I N G : Do not operate the Soloist CP without proper branch protection.
An AC Line Filter may be required for CE compliance and should be located as close as possible to the drive.
For more information about the AC Line Filter, refer to
Section 2.1.4. Wiring between the filter and drive can
be twisted and/or shielded to reduce radiated emissions.
Figure 2-2: Motor Bus Input Connections
Table 2-3: Motor Supply Input Connections (TB102)
Pin Description
Recommended Wire Size
(1)
AC1 240 VAC Motor Power Input
1.3 mm
2
(#16 AWG)
AC2 240 VAC Motor Power Input
1.3 mm
2
(#16 AWG)
Protective Ground (required for safety)
1.3 mm
2
(#16 AWG)
(1) Refer to local electrical safety requirements to correctly size external system wires.
Table 2-4: Mating Connector Part Numbers for the Motor Supply Connector
Description Aerotech P/N Phoenix P/N
Tightening
Torque (Nm)
Wire Size:
mm
2
[AWG]
7-Pin Terminal Block ECK01114 1754546 0.5 - 0.6 3.3 - 0.516 [12-30]
www.aerotech.com Chapter 2 27