Aerotech Soloist CP 10, Hardware Manual

Page: 103 / 112

Maintenance Soloist CP
Table 5-2: Control Board Jumper Configuration
Jumper Setting Description
JP3
1-2
(1)
Watchdog enabled
2-3 Watchdog disabled
JP4
1-2
(1)
No shunt option present
2-3 Shunt option present
JP6
1-2
(1)
24 V operation (High Speed Input 4)
2-3 5 V operation (High Speed Input 4)
JP7
1-2
(1)
24 V operation (High Speed Input 5)
2-3 5 V operation (High Speed Input 5)
1. Default
Table 5-3: Control Board Fuse Information
Fuse Description Size Aerotech P/N Manufacturer's P/N
F1
-S Option Shunt Fuse 1 A S.B. (5 mm) EIF01052 Littelfuse 215001.P
-EXTSHUNT Option Shunt Fuse 2.5 A S.B. EIF01053 Littelfuse 21502.5P
F3 Control Power Fuse 2 A S.B. EIF01029 Littelfuse 3721200041
F4
Soloist CP 10; VAC Input at TB102-1 5 A S.B. (5 mm) EIF01023 Littelfuse 215005.P
SoloistCP 20; VAC Input at TB102-1 10 A S.B. (5 mm) EIF01006 Littelfuse 218010
SoloistCP 30; VAC Input at TB102-1 10 A S.B. (5 mm) EIF01006 Littelfuse 218010
Table 5-4: LED Description
LED Description
ENB/FLT
Turns green to indicate that the axis is enabled. Turns red to indicate a fault condition. The
ENB/FLT LED will flash between RED and GREEN if the drive is enabled and in a fault
condition.
MARKER Turns green to indicate that the marker input is high.
PWR* Turns green when power is applied.
POS Turns green to indicate that the axis is in position.
* If the power light flashes continuously and the unit does not operate, there is too much current draw from the 5V power supply or
the control supply voltage level is low.
www.aerotech.com Chapter 5 103