Aerotech NPAQ MR, Hardware Manual

Page: 80 / 82

Npaq MR Hardware Manual Index
H
Hall-Effect Feedback Interface Pin Assignment 31
Hall-Effect Inputs 31
Humidity 10
I
I/O and Signal Wiring Requirements 17
Inrush Current 4
inspect all cables and connections 61
Inspect cooling vents 61
Inspection 61
Installation and Configuration 13
Introduction 1
Isolation 5-6
J
Joystick Interface 56
L
Leakage Current 4
Limit Input Diagnostic Display 35
Line Driver Encoder Interface 26
line filter 16
Linear Amplifier Electrical Specifications 6
low voltage connections 14
M
Maintenance 59
Mating Connector 18
Mechanical Dimensions 8
Minimum Load 6
Minimum Load Inductance specifications 5
Modes of Operation 5-6
Motor Feedback Connections 24
Motor Feedback Connector Pin Assignment 24
Motor Output Connections 18
Motor Phasing Oscilloscope Example 21
Motor Power Output Connections 18
Motor Power Output Mating Connector 18
Motor Supply specifications 5-6
N
Noise 10
O
optional joysticks 57
Opto-Isolated Inputs 43
Opto-Isolated Outputs 41
Output Impedance 6
Output Voltage 6
Output Voltage specifications 5
Overview 1
P
PC Configuration and Operation Information 50
Peak Output Current specifications 5-6
Pollution 10
Position Feedback in the Diagnostic Display 30
Position Synchronized Output (PSO) 47
Position Synchronized Output (PSO)/Laser Firing 47
Power Amplifier Bandwidth specifications 5-6
Powered Motor Phasing 20
Preventative Maintenance 61
Protection 4
Protective Features 5-6
PSO 47
PSO Output Sources 47
PWM Switching Frequency specifications 5
Q
Quick Installation Guide xi
Quick Start Connections xi
68 www.aerotech.com