Aerohive access point, Deployment Manual

Page: 214 / 221

Deployment Guide 213
Appendix A Country Codes
When the region code on a HiveAP is preset as "world", you must set a country code for the location where you
intend to deploy the HiveAP. This code determines the radio channels and power settings that the HiveAP can use
when deployed in that country. For HiveAPs intended for use in the United States, the region code is preset as
"FCC"—for "Federal Communications Commission"—and the country code is preset for the United States. You can see
the region code in the output of the
show boot-param
command.
To set a country code when the region is "world", enter the following command, in which
number
is the
appropriate country code number:
boot-param country-code
number
To apply radio settings for the updated country code, reboot the HiveAP by entering the
reboot
command.
To see a list of the available channels available for the country code that you have set on the HiveAP, enter the
following command:
show interface { wifi0 | wifi1 } channel
. For example, the output for the
show
interface wifi0 channel
command on a HiveAP whose region code is FCC and country code is 840 (United
States) shows that channels 1 through 11 are available. If a channel does not appear in this list, you cannot
configure the radio to use it.
The following list of country codes is provided for your convenience.
Countries and Country Codes
Albania 8
Algeria 12
Argentina 32
Armenia 51
Australia 36
Austria 40
Azerbaijan 31
Bahrain 48
Belarus 112
Belgium 56
Belize 84
Bolivia 68
Bosnia and Herzegovina 70
Brazil 76
Brunei Darussalam 96
Bulgaria 100
Canada 124
Chile 152
China (People’s Republic of China) 156
Colombia 170
Costa Rica 188
Croatia 191
Cyprus 196
Czech Republic 203
Denmark 208
Dominican Republic 214
Ecuador 218
Egypt 818
Note: Be sure to enter the correct country code. An incorrect entry might result in illegal radio operation and
cause harmful interference to other systems.