Advanced Poly-Packaging Ti-1000, Operation Manual

Page: 56 / 70

10. Print Head lowers
when bagger cycles but
does not
print (no error messages on
display)
Print head goes down but
won’t print. 1. No label downloaded
2. Pressure low
3. Label formatted incorrectly
4. DIP switches not set properly
5. Bad print head connection.
6. Print head failure
7. Failure in the rewinding/
feeding of the ribbon.
8. Defective printer cable
9. Failure of the software
10. Defective CPU PC board Download label from PC
Increase air pressure
Shut off printer for 5 seconds,
reload label after checking format.
Check DIP switch settings,
replace print head. See Page 36
Reset print head connectors
Replace the print head
Replace motor assembly.
Replace printer cable
Reload software
Replace CPU PC board
11. Print head goes down
but won’t come back up
and bags tear on T-1000.K 1. Defective valve or
connection.
2. Incorrect cam position (refer
to item 6 on pg. 61
3. Ribbon Check to see if LED on valve is
turning off. Push manual orange
button or valve to see if head is
going down, then release to come
back up.
With the air off on the bagger
the Ti-1000 air is now off. Turn the
print head knob clockwise, if it
doesn’t move, the cam pushing
down on the spring plate moved to
far forward. Turn the knob counter
clockwise to allow the cam to reset
on the spring, then reinstall the air.
Ribbon could be sticking to bag,
refer to Problem “Ribbon sticking to
bags when printing”.
12. Print head won’t go
down. 1. Check air pressure
2. Check air valve connection
3. Check air valve
4. Defective I.F. Board
Check to see if pressure is on 80
PSI on the T-1000, and 50 PSI on
the printer regulator.
Check LED on valve under
small cover, the light will go out
when the foot switch is depressed.
If the light doesn’t go out, check
24V on terminal to solenoid.
Push manual operate button on
valve (orange button) up & down.
At this time the print head should
move, if not replace the valve.
Replace I.F. board.
13. After replacing the
print head, how do you
clear print head “Linear
Inches” to determine
warranty. If new print Defective Print Head Warranty I. Turn power off while holding
feed and pause, turn the power on,
dialog screen should say: <1> on
the display.
II.
Press the feed key (4) times to