Advanced Poly-Packaging Ti-1000, Operation Manual

Page: 25 / 70

2.9 Print Registration and Position Alignment
Prior to moving the print position, ensure that the web is properly threaded and is tracking left to right.
Also ensure that the web is properly registered so that the web stops in the correct position.
If the web is not properly tracking or not registering with the bagging machine's tolerances, consult the
bagger manual for proper adjustments to tracking and registration.
On the T-1000, ensure the roller guides are properly positioned within 1/8" from the edge of the bags,
both on the printer
guide roller and the T-1000 guide roller . (Fig. 2-8, item 5)
Left to Right Print Position
Positioning and alignment may be achieved by moving the print head assembly left or right and moving
the
alignment roller up or down. (Fig. 2-8)
To move the print position left or right (side to side against machine direction), pull or push the
handle.
The weight of the print head assembly and the friction of the bushings on the shafts is sufficient to hold
the assembly in position.
Note: If the printer is mounted to print on film running vertically through the print head, shaft clamps
may be added to secure the print head assembly in position.
Top to Bottom Print Position
To initially align the print close to the position desired, simply press the alignment roller assembly
downward to lift upward moving the desired print position immediately beneath the print head . When
the bagger is cycled, slightly lower or raise the alignment roller moving the print to the desired location.
(Fig. 2-8) The
alignment roller should move up and down freely by hand. However, the cycle
operation of the bagger should not allow the alignment roller to move. To increase tension on the
alignment roller to prohibit the roller to move during cycling, rotate the
tension knob clockwise. (Fig.
2-8)
Note: If the web of bags threaded through the machine breaks prematurely, further adjustment may be
required. (See Chapter 7, Trouble-shooting)
Note: If the seal position of the bagger is adjusted, the print position must also be adjusted to
compensate.
2.10 Note on Adjustments of the Ti-1000
Upon receipt by the purchaser, it is not unusual for the Ti-1000 to be out of alignment due to shipping
and excessive handling. Unless physically damaged, the T-1000 will function properly after minor
adjustments are accomplished.
Read Chapter 4 for information on adjustments of the Ti-1000.