Advanced Poly-Packaging Ti-1000, Operation Manual

Page: 63 / 70

48. Ti-1000 When
printing on bags, You get a
ribbon wrinkle mark on the
bag. Head is to far from platen rouer.
Lower head and readjust linkage and
adjust print head.
49. Big Black triangular
block printing on bag. Defective ribbon (Data) cable.
Ribbon on take up has to much
slack.
50. Print head does not
lower when bagger cycles.
1)
Printer “OPTION” not
enabled
2) Air to printer disconnected /
air pressure too low.
3)
Print head connections
loosen.
4)
LED’s print signals “OFF”
5)
Print head cylinder / Valve.
Turn
“ON” printer from option screen.
Check
air regulator / air pressure 50 PSI
minimum.
Check
print head connectors.
Check
LED’s D3 / D4 if “OFF”: Check
connection between H3 on the I.F.
Board & CN15 on the CPUBoard.
Check
cylinder #8 by activating valve #10
manually. Check valve #10: 24V
DC.
51. Print head lowers
when bagger cycles but
does not print (no error
message is displayed) 1) No labels are downloaded.
2) Air pressure too low.
3) Label formatted incorrectly.
4) Di pswitches not set
properly.
5)
Head down sensor.
6) Print head failure.
7) Failure from the rewinding /
feeding motors.
8)
Lever / arm mechanism.
9) Failure of the CPU board.
10)
Failure of the Printer cable.