Advanced Poly-Packaging Ti-1000, Operation Manual

Page: 32 / 70

3.9 Interface Board
LED Indicators
Refer to Figure 3-9 for the location of the following LEDs.
TYPE LED
No.
DESCRIPTION
D1 Head down sensor ON when head is down
D2 Bag out sensor ON when bags are out
D3 Printer printing signal OFF when printer is printing
INPUTS D4 Printer printing signal OFF when printer is printing
D5 Auxiliary input signal ON when AUX signal present
D6 Verifier input signal (optional) ON when verifier signal is
present
D7 Verifier attached (optional) ON when verifier attached
D8 Input 5 NOT USED
D9 Printer Busy Signal OFF when printer is cycling
D10 Printer Stop Signal ON when printer error occurs
D11 Verifier Synchronization
signal (optional) ON when synchronizing verifier
OUTPUTS
D12 Output 2 NOT USED
D13 Output 3 NOT USED
D14 Output 4 NOT USED
D15 Head down signal ON when energizing head down
valve
D16 Print start signal OFF when sending start pulse
Connectors
Connectors, LED lights, and other components are identified on the Interface boards illustrated in Fig.
3-10.
TYPE No. DESCRIPTION HARNESS LOCATION
H2 Head down sensor / Bag
out detector input
connector. Connects to the head down sensor
and Bag out detector through the
umbilical line to the head
assembly.
INPUTS H3 Printer printing input signal
connector Connects to CN15 on the main
controller Board
1
.
H4 Verifier input / presence
signal input connector
(optional) Connects directly to the bar-code
verifier
2
via a 15 pin D-sub
connector.
INPUT /
OUTPUT
H5 Auxiliary I/O, printer busy,
printer stop connector Runs beneath the interface board
down to the AUX INPUT
connector.
INPUT H6 Power / printer sensor
interface connector Connects to CN9 and CN18 on the
main controller Board
1
. +5V can
be found on pin 6 of CN18.
H7 Verifier synchronization
signal connector (optional) Connects directly to the bar-code
verifier
2
via a 15 pin D-sub
connector.
OUTPUTS H8 NOT USED
H9 Head down valve signal Connects to the head down valve