Advanced Poly-Packaging Ti-1000, Operation Manual

Page: 55 / 70

1. Message screen does
not display 1. Power off
2. Loose connection
3. Fuse blown Plug in power cord / turn on
Tighten connections
Replace fuse(s)
2. How do you check
parameters on display? Refer to problem “Ribbon
advances after down load”
option 3. See Section 7.3 on changing
parameters.
3. Lights on PC boards do
not light 1. Blown fuse
2. Cables not seated Correctly
3. Short in cables
3. Damaged PC boards Replace fuse(s)
Reset cables
Replace cables
Replace PC boards
4. Display has square lines
instead of saying “On line” Check display connections to
assure that all connections are
tight. Check Display for correct
voltage. Should be around 5V.
Red/White/Black to Orange.
Replace display
Replace orange & white cable
from the display plug to board.
(Red/White/Black to Orange will be
5V).
5. Print Head does not
lower when bagger cycles 1. Air to printer
disconnected/low
2. Printer Option not enabled
3. Defective Valve Air line / increase pressure
Turn printer on in T-1000
“Options Menu”.
Check LED’s on Solenoid
Should go out to lower print head.
6. No main power light 1. Blown fuse
2. Defective switch
3. Input voltage is not within
the rated voltage
4. CPU/PC board not receiving
voltage from power supply.
5. Defective CPU board. Replace fuse
Replace power switch
Check voltages; replace power
cable.
Check for 5V on unit connector
on CPU board.
Replace CPU board
7. Screen Readout is
scrambled or all lines. This reading is a bad orange
CN3 - White CN-1 cable.
IOP cable could be bad.
Display should read “On Line”
8. Bagger power “on” Ti-
1000 option “ON”, but Ti-
1000 power is off. When you turn Ti-1000 “ON”
screen on T-1000 came up with
“Are labels leaded Error,” and you
could not eliminate screen error
when pushing screen. Replace If
board -- printer readout LED was
blinking.
9. With all the correct
settings in software. When
customer downloads label
format into Ti-1000, LED
flashes, then stops
flashing, No Labels were
accepted when you press
pause. Using Software other than
Labelview Do a parameter clear to solve the
problem.