Advanced Poly-Packaging Ti-1000, Operation Manual

Page: 50 / 70

6.6 Preventative Maintenance Checklist
ITEM DESCRIPTION
PERIOD
Air regulator Adjust pressure from 40 to 60 PSI (dependent upon print
quality) D
Rubber rollers Clean with alcohol (clean cloth rag), daily or after each
ribbon roll change (more often in dirty environmental
conditions D
Print head Clean with alcohol (cotton Q-tip), daily or after each
ribbon roll change (more often in dirty environmental
conditions D
Aluminum rollers Clean with alcohol D
Wiring / Connectors Inspect for loose wiring / connectors, tighten as needed M
Air lines / Valves /
Cylinders Inspect for loose air lines, listen for leaks, tighten or
replace poly tubing as needed M
Compartments / Covers Remove all covers, clean and blow out compartments
with
compressed air to remove dust and dirt M
Side-plates Clean and wipe down with lightweight oil (based upon
environmental - humidity conditions) M
Drive belts Inspect for wear / fraying, replace if needed M
Gears Inspect for particulate matter and remove if necessary. M
!
CAUTION: Unplug power cord and disconnect air line prior to removing guards or print head.
Failure to do so may result in electronic failure.
Preventative Maintenance must be performed by qualified maintenance personnel.