adept technology GRouter3, User Manual

Page: 34 / 69

Redundant Router Detect : ese radio buttons allow the user to enable or disable the detection of
redundant 852 routers on the 852 channel. When enabled, no CN data packets are forwarded to
any redundant routers. is prevents loops due to redundant routers from occurring. Click
Submit Changes and the new value is immediately in effect.
Loop Check on Boot : ese radio buttons allow the user to change the boot up mode of the router
with respect to loop detection. When enabled, the router will not forward CN data packets until
aer a loop check has completed and no loops were detected. is adds an additional delay at
boot-up before the router will begin forwarding packets. e length of the delay is equal to the
Loop Detect Interval times the number of Loop Recover Retries . When disabled, the router will
immediately begin forwarding packets on boot-up. Click Submit Changes and the new value is
immediately in effect.
Submit Changes : is button updates all the configuration information entered on the current
web page and refreshes the display.
Trigger Service Pin : is button causes a service pin message to be sent out both the 709.1 and IP
interfaces of the router. is can be used when commissioning the router remotely.
Register With Config Server : is button sends an 852 registration request to the config server.
is will usually add the device to the config server’s list of managed devices.
Launch Upgrade FTP Server : is button starts up the FTP server needed to perform field
upgrades of the GR3 router's firmware. A detailed description of the upgrade process is provided
in a later section.
Reboot : is button performs a so reboot of the main processor on the router. is is needed any
time the ports are changed or the 852 Bridge mode is changed. When rebooting the following
page will be displayed.
Fig.2.10: Reboot Page
Once rebooting has completed reenter http://10.0.2.40 or whatever the IP address of the router is
to go back to the
Status page.
-34-