• Go to the
Twin Status Page
to observe operational state and failure statistics.
• e monitoring application on each router is now ready to be commissioned. Repeat the
following steps for each router.
• Drag a new device shape onto the LonMaker drawing. e device should be attached to the
channel on the LON side of the GR3 router. Setup and commission this device. Use the SRV
App to send a service pin for the monitoring application.
• Drag a new functional block onto the lonmaker drawing and associate it with the newly
created device. e status and alarming network variables are now ready to be bound.
e sequence of dialog boxes you will encounter is given below.
LonMaker New Device Dialog
-64-
Summary of Contents for GRouter3
