Fig.2.12: IP Setup Page
MAC Address
: e physical address of the Ethernet interface in HEX. is is a read only field.
IP Address
: e IP address currently assigned to the Gateway. is is the unicast IP host address
of the router. To change the value in the field, type in the new value in the dotted format
XX.XX.XX.XX
and click the
Submit Changes
button. e IP host address change will not take
effect until aer the router is rebooted. Be careful to record the new address as it will not be
possible to communicate with the GR3 without a valid IP address.
Subnet Mask
: e IP subnet mask assigned to the router. To change the value in the field, type in
the new value in the dotted format
XX.XX.XX.XX
and click the
Submit Changes
button. e
subnet mask change will not take effect until aer the router is rebooted.
Gateway
: e address of the IP router or gateway used by the GR3 router to reach other devices
that are not in its local network. To change the value in the field, type in the new value in the
dotted format
XX.XX.XX.XX
and click the
Submit Changes
button.
WebServer Port
: is field allows the user to change the IP port used by the embedded web server
on the device. e default is port 80. When used with a NAT router and port mapping, port 80
-38-
Summary of Contents for GRouter3
