4.3.8 Inspect on delivery
1. Inspect all packings for visible damage.
2. Open every damaged box and inspect the contents for damage.
3. Immediately fill a claim form with the carrier if any fixture is damaged.
4. Store the fixture in its original packing in a protected area.
Note
If damage to any equipment is noted, file a claim form with the carrier immediately.
WARNING
Do not damage the cable insulation.
CAUTION
Do not unpack the fixture before it is at the installation site to avoid damage due to transportation and handling.
4.4 Toe-in
Toe-in of light fixtures can be achieved in two ways:
1. By installing the light fixture in taxiway parallel bases and use light fixtures with built in toe-in.
2. By installing the light fixture in bases installed at an angle relative to the taxiway and use light fixtures with no built in
toe-in.
If bases which are installed at an angle are used, provided that they are installed correctly, straight light fixtures (i.e. with no
toe-in) should be used.
The following chapter only regards the case where light fixtures are installed in runway/taxiway parallel bases, i.e. where no
toe-in is achieved by angled bases.
There are two major categories regarding the toe-in in taxiway light fixtures:
Straight light fixtures
These light fixtures have a straight light beam
Light fixtures with mechanical toeing
These light fixtures have a top cover with the toe-in cast in place at an appropriate angle
Figure 7: Toe-in
Mechanical toe-in,
Side 1 left toe, side 2 right toe,
ICAO curved ;
FAA L-852J/K(L)
ICAO narrow/w
ide;
FAA L-852A-D(L)
AXON Taxiway Inset Lights, 8-inch and 12-inch
Installation
20
Copyright
©
ADB Safegate, All Rights Reserved
Summary of Contents for AXON FAA L-852A
Page 2: ...UM 5056 Rev 1 0 17 2022 12 08 ...
Page 98: ......
