5.3.8 Replacing the secondary Cable — SJO cord set
Figure 16: Secondary cable replacement
Tools to be used:
•
Screwdriver T25 bit
•
Flat-head screwdriver
•
Small flat head screwdriver
1. Open the light.
Note
Refer to the
Opening a Light Fixture — disconnecting the Bottom Pan from the Top Cover
section.
2. Disconnect the cable:
a. Disconnect the secondary cable from the converter by placing a small flat-head screwdriver into the opening located
at the other side of the secondary wire, and
b. Release the cable by prying the screwdriver on the cable release opening.
3. Unscrew the Strain-relief Bolt and its plate.
Make sure you dispose the old Strain-relief Bolt and its plate and use the new material.
4. Unscrew the cable clamp.
Make sure you dispose the old bolt, washer and lock washer and use the new material.
5. Remove the secondary cable
Make sure you dispose the old secondary cable and use the new secondary cable.
6. Replacement:
a. Pull the secondary wires through the Strain-relief Plate and
b. Mount the new secondary cable by torquing the new strain relief bolt at XX in-lbs XX Nm.
7. Tighten the new cable clamp bolt with the washer and lock washer at XX in-lbs XX Nm.
AXON Taxiway Inset Lights, 8-inch and 12-inch
Maintenance
36
Copyright
©
ADB Safegate, All Rights Reserved
Summary of Contents for AXON FAA L-852A
Page 2: ...UM 5056 Rev 1 0 17 2022 12 08 ...
Page 98: ......
