3 2
SECTION 15
SERVICING
Isolate the fire from the gas supply.
Ensure that the fire is fully cold before attempting service.
A suggested procedure for servicing is detailed below:
1. Lay out the dust sheet and tools required.
2. Remove the cast front fret.
3. Carefully remove the ceramic components
4. Remove the two screws that retain the tray in place and disconnect from the
isolation tap.
5. Remove the burner tray and other components as required (i.e. remote control box)
6. Disconnect the gas supply to the appliance and disconnect the isolation tap
7. Remove convector box by, firstly protecting the hearth from potential damage,
unroll the coiled tensioner cables from the rear of the firebox, remove the securing
nipples and tensioner adjusters. The firebox is now released from the opening and can
be slid outward onto the hearth.
8. Check the fireplace opening for rubble accumulation and remove, if debris is
excessive, initiate remedial work on the flue.
9. Check the flue with a smoke pellet for correct operation.
10. Refit convector box using new seals where necessary
11. Strip off the burner pipes and clean thoroughly.
12. Clean out the injector, pilot assembly and burner tube. DO NOT remove the pilot
injector.
13. Re-assemble and re-fit the burner tray.
14. Turn on the gas supply, and leak test.
15. Refit the decorative casting and ceramics.
16. Check any purpose provided ventilation is un-obstructed.
17. Light the fire and test for spillage.
18. Check setting pressure and safe operation of the appliance.
Summary of Contents for Eco4
