2 2
SECTION 7.2
SECTION 08
The Sensor MUST be able to be seen when the decorative fascia is in place, the
sensor may require relocating when used with alternative Fire Fret/Front.
FUEL BED LAYOUT
Do not place the
remote sensor any where
above this point.
Remote sensor
Place two B Coals at each
end of the front matrix and
the rear matrix as shown.
Do not block the area
between the coal supports.
Place the three coals A as
shown again ensuring that
the area between the coal
supports is clear.
Place the two coals B at
each end of the rear matrix
behind the two coals as
shown.
Place the ceramic rear matrix onto
the burner ensuring that the rear
matrix is sitting behind the two
fixed brackets, the back of the
matrix rests against the back panel
fitted at the rear of the box.
Place battery holder
and cover here
Summary of Contents for Eco4
